Elecraft W2 Watt-meter Manual Manuel d'utilisateur télécharger pdf (Page 12)

Remove the screw holding the spacer between U3 and the pc board and mount the bottom cover as shown

in Figure 7. Be careful not to dislodge the spacer. If it falls out, you must remove the cover and replace it as

shown in Figure 2.

Figure 7. Mounting Bottom Cover.

CAUTION

Do not put stress on the pc boards when installing the screws in the following step.

Secure the bottom cover with four 3/16” (4.0 mm) black pan head screws. No lock washers are used. Note:

It is best not to tighten the screws until the enclosure is fully assembled so the panels can move slightly as

needed for best alignment. This is a good practice to follow when installing all of the outer case

components.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Pas de commentaire

Elecraft W2 Watt-meter Manual Manuel d'utilisateur Page 12