Elecraft W2 Watt-meter Manual Manuel d'utilisateur télécharger pdf (Page 11)

Mate plug P1 on the bottom of the main board with jack J1 on the front panel board as shown in Figure 5.

Note that one pin on P1 has been removed and a plug is placed in the corresponding hole in J1. This is to help

avoid misaligning the connectors. Be sure the connectors are aligned and fully mated as shown.

Figure 5. Mating the Front Panel and Main PC Boards.

Locate the bottom cover and remove the paint from the inside around the corner screw holes as shown in

Figure 6so the cover will form good electrical contact with the standoffs and 2D fasteners when it is mounted.

Figure 6. Preparing the Bottom Cover for Mounting.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Pas de commentaire

Elecraft W2 Watt-meter Manual Manuel d'utilisateur Page 11