ELECRAFT KRX3 Manuel du propriétaire télécharger pdf (Page 8)

In the following steps you will handle small TMP coaxial connectors. These are friction-

fit connectors shown in Figure 3. Handle the connectors by the grips as shown. Do not pull

on the coaxial cable.

Figure 3. TMP Cable Connectors.

Hold the KRX3 module by the two brass knurled nuts on the top, and lift it straight up to gain access to the

small TMP coaxial connectors plugged into the module. There are two along the front. There may be one at the

back as well, depending upon the options installed. As you lift the KRX3 module, it will unplug from two small

interface circuit boards. One is at the front and the other is at the rear. These small boards may come out with

the module or they may remain attached to the K3 main RF board.

Unplug the TMP coaxial cables leading to the KRX3 module, then lift the module free and set it aside.

Locate the two small interface circuit boards (see TBD and TBD), remove them and put them in a safe

place.

Removing the Bottom Covers and KIO3 Board

Remove the four jack screw nuts with their lock washers and the two black pan head screws from the KIO3

rear panel as shown in Figure 4.

Figure 4. Removing KIO3 Panel.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

ELECRAFT KRX3 Manuel du propriétaire Page 8