ELECRAFT KRX3 Manuel du propriétaire télécharger pdf (Page 6)

Parts Included

The following parts should be included in your kit. Check to ensure you have them all. If any parts are damaged

or missing, contact Elecraft for replacements (see Customer Service and Support, page 3).

ILLUSTRATION DESCRIPTION QTY.

ELECRAFT

PART NO.

XV3 Printed Circuit Board Assembly

ESD Sensitive.

1 E850244

XV3 Connector Panel 1 E100224SS

KXV3 TMP Cable Assembly 1 E850292

Screw, 4-40, 1/2” (13 mm)

2 E700030

Lockwasher, 4-40, inside tooth

2 E700010

Nut, 4-40

2 E700011

Installation Procedure

SPECIAL NOTE FOR K3 KIT BUILDERS: If you were directed here by the K3 Kit

Assembly Manual to install your KXV3 Module, inventory the parts in this kit against the list under Parts

Included on page 6 then begin installation at the step indicated on page 10.

Removing the Top Cover

Disconnect power and all cables from your K3.

Remove the nine screws to free the top cover as shown in Figure 1. After the cover is open, lift it gently to

reach the speaker wire connector. Unplug the speaker then set the top cover aside in a safe place.

Whenever you remove screws from a panel, if one screw seems too tight to loosen

without damaging it, first loosen the other screws then try again. Sometimes one screw

binds in its hole when the other screws are tightened.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Pas de commentaire

ELECRAFT KRX3 Manuel du propriétaire Page 6