ELECRAFT K3-Remote Manuel d'utilisateur télécharger pdf

1. Hardware

Local rig consists of

RRC-1258 MkII box, TP-Link TL-WR343ND router/access point and a laptop

running Windows 7 OS. Dynamic microphone - old Yaesu MD-1

Connection cable from between microphone and remote box - from Yaesu MD-100.

The purpose of router is to pickup Wi-Fi signal and to convert it to LAN (cable) which is needed for

the remote box. Since I mostly operate from hotels, the router is very handy.

Though, it is also possible to install wireless module instead of router, bus it cost around $100 vs

$50 for router.

Beside of that, the router, once configured does not require every day login, which is common in

many hotels.

Remote rig consists of remote box connected to Elecraft K3 transceiver.

Recently I started accessing remote rig via Elecraft K3/0-Mini, see pictures below:

1 2 3 4 5

Page 1

1. Hardware Local rig consists of RRC-1258 MkII box, TP-Link TL-WR343ND router/access point and a laptop running Windows 7 OS. Dynamic microphone -

K3/0-Mini 2. Configuration Initial configuration of local box made by Microbit Setup Manager thru USB port on front panel of the box.

Page 3

If remote box on radio side has already installed and configured, after pushing “Connect” button receiving signal should be heard. 3. How to control

Page 4

In my case it was COM20, the speed of 38400 is default for Elecraft K3. So, to start remote control, I go to http://192.168.1.227:8090/ then “Statu

Page 5

6. Password If someone decides to set a password on remote and control box, make sure you enter it as a sip password. Otherwice no con

Pas de commentaire

ELECRAFT K3-Remote Manuel d'utilisateur