ELECRAFT KRX3 Spécifications télécharger pdf (Page 6)

Parts Included

The following parts should be included in your kit. Check to ensure you have them all. If any parts are damaged

or missing, contact Elecraft for replacements (see Customer Service and Support, page 3).

ILLUSTRATION DESCRIPTION QTY.

ELECRAFT

PART NO.

KBPF3 Printed Circuit Board

ESD Sensitive. Follow ESD safe handling

procedures. Keep in ESD-safe bag until

installed.

1 E850269

Standoff, 4-40, 1/2” (13 mm) 2 E700061

Screw, 4-40, 1/4” (6.4 mm) 4 E700005

Lock Washer, #4 split 6 E700004

Installation Procedure

As you install components and reassemble your K3, be sure all the screws are in place

and secure, but do not over tighten them. Failure to tighten all screws may result in poor

shielding of sensitive components, resulting in possible noise or birdies in the receiver as well

as other difficult-to-trace problems.

Removing the Top Cover

Disconnect power and all cables from your K3.

Remove the nine screws to free the top cover as shown in Figure 1. After the cover is open, lift it gently to

reach the speaker wire connector. Unplug the speaker then set the top cover aside in a safe place.

Whenever you remove screws from a panel, if one screw seems too tight to loosen

without damaging it, first loosen the other screws then try again. Sometimes one screw

binds in its hole when the other screws are tightened.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Pas de commentaire

ELECRAFT KRX3 Spécifications Page 6