Elecraft PR6-10 Manual Errata Manuel d'utilisateur télécharger pdf

PR6-10 MANUAL ERRATA

Rev. A-1, January 7, 2015

1. Page 1, Introduction, third paragraph, change “open-source” to

“open-collector”.

2. Page 2, Installation and Operation, Elecraft K3: A Y-cable with

phono connectors is provided to allow you to connect two

devices, such as both the preamplifier and the P3 Panadapter, to

the K3’s 12VDC Output as shown below:

2. Page 2, Installation and Operation, Elecraft K3 Control (CTRL)

Input: If you are adding the preamplifier to a K3 that already has the

optional KPAK3AUX cable attached to the AUX output and you

want to switch the PR6-10 on and off when the 6 or 10 meter band

is selected with the DIGOUT1 signal, connect the DB-15 Y cable

supplied with the KPAK3AUX cable set and the DE15 Line

Interrupter supplied with your PR6-10 as shown below.

PR6-10 MANUAL ERRATA

Rev. A-1, January 7, 2015

1. Page 1, Introduction, third paragraph, change “open-source” to

“open-collector”.

2. Page 2, Installation and Operation, Elecraft K3: A Y-cable with

phono connectors is provided to allow you to connect two

devices, such as both the preamplifier and the P3 Panadapter, to

the K3’s 12VDC Output as shown below:

2. Page 2, Installation and Operation, Elecraft K3 Control (CTRL)

Input: If you are adding the preamplifier to a K3 that already has the

optional KPAK3AUX cable attached to the AUX output and you

want to switch the PR6-10 on and off when the 6 or 10 meter band is

selected with the DIGOUT1 signal, connect the DB-15 Y cable

supplied with the KPAK3AUX cable set and the DE15 Line

Interrupter supplied with your PR6-10 as shown below.

1

PR6-10 MANUAL ERRATA 1

Résumé du contenu

Page 1 - PR6-10 MANUAL ERRATA

PR6-10 MANUAL ERRATA Rev. A-1, January 7, 2015 1. Page 1, Introduction, third paragraph, change “open-source” to “open-collector”. 2. Page 2, Instal

Commentaires sur ces manuels

Pas de commentaire